Precision-turbo-and-engine NLR AMS-500 Boost Controller Manual de usuario

1 AMS-500 Boost Controller Overview The AMS-500 Boost Controller can control 2-Stages and/or levels of boost. The 2-Stages are controlled by Input1

2 Table of Contents Configure AMS-500 Operating Mode Page 3 Configure Stage1 / Input1 Operating Mode Page 4 Setting Input1 and Input2

3 Configure AMS-500 Operating Mode Normal Mode—When the AMS-500 is configured for Normal Mode of operation it will always attempt to reach the targ

4 Configure Stage1 / Input1 Operating Mode Normal Mode—When Stage1 and/or Input1 is configured for Normal operation the AMS-500 will immediately ap

5 Setting Input1 and Input2 Activation Polarity Overview—Input1 and Input2 can be configured for either Ground activation or +12 volt activation. Th

6 Setting Stage2 Boost Level and Ramp Rate Overview—The Stage2 Programming switches are used to set the target psi when In-put2 is active. To determ

7 Wiring Diagram IMPORTANT—The AMS-500 controls the pressure on the Waste Gate so the actual boost level obtained is a combination of the Waste Gate S

8 Warranty Information NLR warrants to the original purchaser that the AMS-500 Controller Shall be free from defects in parts and workmanship under